Jaeger Precision
Jaeger Precision Titan Nub for the Tokyo Marui MWS Series
Jaeger Precision Titan Nub for the Tokyo Marui MWS Series
| Minimum Cart Quantity | Discount | Wholesale Price |
|---|
| Minimum Cart Amount | Cart Discount |
|---|
Couldn't load pickup availability
If you are fitting an upgrade nub into the MWS gas rifle, it is one of the cheapest upgrades you can do with great gains compared to the standard setup.
There is however an inherent issue in regards to how the hop pushes on the nubs. No matter which nub you are using the arm will rotate the nub towards the rear of the hop unit. This means even though you may be using a nub that has a larger contact area, when hop is applied the nub rotates and you don’t benefit from the full contact patch as it applies pressure on the corner.
The Jaeger Precision Titan Nub fixes this by adding more contact point to keep the nub straight as it is pushed downwards. There is only so much contact patch you can get with the standard hop up unit however I feel this is the best way to maximise contact through the pressure path of the hop arm. The guide fins will keep the nub centre and straight for the best possible pressure.
Share
Today tried to install the titan nub on my DE Noveske N4 and I can confirm there is absolutely no chance it can fit. Sure I saw the video which shows how to file down the hop-up arm. I don't have the issue shown in the video, but I have 3 other major ones:
1. the arms of the nub are too thick, they can barely fit in the hopup cuts on both sides, had to file the arms of the nub in order to make them slimmer so they can fit and freely slide up and down.
2. The arm of the hopup doesn't align with the upper part of the nub, so the nub can't fit into the groove of the arm.
3. The nub seems slightly wider, so when I assemble the hopup unit, I can barely fit it back inside the barrel and when I do, the titan nub is stuck inside, pressed hard by the body of the hop-up unit inside the barrel, which makes it impossible to move up and down.
Long story short, it doesn't work for my DE Noveske N4, which I bought around 4 months back from TaiwanGun. Do note, my N4 came with a lot longer barrel than the one you show in your video, so there is a possibility it is a new revision, with slightly changed dimensions of the hop-up unit.
I am a bit dissapointed, not gonna lie, because the part looks solid and I had hopes to improve the accuracy, due to my gun being quite inconsistent at long ranges, no matter what Nub/Rubber combo I try.
Haven't tried it yet but it looks like solid quality
easy to install, cost effective and very innovative. this should be one of the 1st upgrades you should do with out question.
The nub was golden paired with my unicorn bucking.modification is required if you’re running aftermarket chambers.hope you will make a hop up chamber that fits.stock chambers are hard to find
Easier fitting than an omega nub, plus the fins help keep it level